Remote Wire Causing Amp To Protect

Remote Wire Causing Amp To Protect

Does the cable from remote control to amplifier put you in protection mode? 3

Okay fine. Why!

update

The remote control cable is connected to the stereo, when I plug it into the amplifier, it goes into safe mode. But when I take it off, the light goes out.

This is not the fault of the children of your time. This is the fault of your amplifier. When the amplifier is off, mute the sound and try to reset it. If you do not turn off your amplifier, it may need to be repaired.

You need to connect the remote control cable to your stereo. The remote control cable turns it on when the stereo is on and turns off the amplifier when the stereo is off. The remote control cable from this amplifier should be connected to the stereo cable, usually the blue cable comes from the stereo. You can also buy additional circuits by going to the collar and attaching a remote control cable. Incorporating a circuit includes instructions on how to use it.

Remote Wire Causing Amp To Protect