Overhead Door Phantom

I have a Phantom Garage door opener that doesn't close, does it open properly? 3

Does anyone else have this problem ???

Power is not a problem ... I have to turn it off manually ... it opens correctly with the remote control after each manual turn off

There seems to be a problem with the seat belt / PTO cell. Each sensor in the Phantom unit has an LED light. Both should be on at all times and not flash. If any of them blink, it indicates that they are incorrectly connected or obstructed. If only one is connected, you have a faulty cable or sensor. If you can't find brakes or brakes in the sensor's low voltage wires, they need to be replaced. The Phantom is manufactured by Overhead Corporation. Then any parts port dealer can help you. Call 1800929DOOR to find a dealer near you.

Overhead Door Phantom

Repairing the Phantom Garage Door Opener
This page can help you.
D:
I have a Phantom Garage door opener that doesn't close, does it open properly?
Does anyone else have this problem ???
Power is not a problem ... I have to turn it off manually ... it opens correctly with the remote control after each manual turn off
Check that the laser sensors are connected. Not if they blink. If they are aligned, you can adjust the pressure or contact a garage door specialist.
Looks like you need to adjust the opening stroke to close completely.

Overhead Door Phantom - How To Discuss